Logic Pro keeps crashing when I add a sample from Splice

Question

Level 1

4 points

Logic Pro keeps crashing when I add a sample from Splice

I have a fresh session open with basically one track from the drum designer plugin in it. When I try to add samples from splice, Logic Pro crashes. It only occurs with certain samples I notice, because some work and are added like normal. This is a relatively new phenomenon, as I have used Splice a lot for a couple years with no issue. The only thing I can think of is the nature of the samples, but Splice doesn't really have any info distinguishing the samples other than just them being a .wav file. I'm set at 44.1 kHz sample rate.

MacBook Pro (2021)

Posted on Jun 2, 2023 2:08 AM

Reply

Answer 1

⚠️

Top-ranking reply

jdreinberg Author

Level 1

4 points

Jun 18, 2023 6:29 PM in response to Adi Jaffe

No worries. Right-click the Logic Pro icon in your applications folder and click “get info”. There should be a check mark toggle for running with Rosetta 2.

Reply

Answer 2

jdreinberg Author

Level 1

4 points

Jun 17, 2023 2:50 PM in response to deadcovenants

So this may not apply to everyone's problem, but I ended up realizing my Logic Pro was set to run in Rosetta 2. Splice had been working with my Logic Pro Rosetta 2 prior, cause like I said, it's been working fine until the past few months I had this issue. However, I turned that off and I have been able to add samples from Splice no problem. There likely was a recent update with Splice. "As of Desktop release 4.2.9, Splice now has native Apple Silicon support." from Splice's support site.