On the lower part of the ruler, where your playhead rests, are these divets which represent the subdivisions of the beat whether the project be in 4/4, 5/4, etc. Does anyone know how to show visible numbers on that lower part of the ruler so you can see like 1/4, 2/4, 3/4, 4/4, and then repeat for each beat. I think I have searched the entirety of the internet trying to find an answer. Thank You!
Hi, you can do this by increasing the horizontal zoom value, like so:
Though, individual beat values might not be displayed as "1/2", "2/2" and so on, exactly. Rather, the version of Logic I'm running goes something like "12", "22" or "112", "113", and so on, depending on the zoom resolution value. Perhaps, it may be different in the most recent versions.
Hi, you can do this by increasing the horizontal zoom value, like so:
Though, individual beat values might not be displayed as "1/2", "2/2" and so on, exactly. Rather, the version of Logic I'm running goes something like "12", "22" or "112", "113", and so on, depending on the zoom resolution value. Perhaps, it may be different in the most recent versions.
Thank you but it's not exactly what I'm asking for. You see that does change the upper part of the ruler. Is there a way to show it on the bottom part so I can see the numbers on the 3 marks. and Im not sure if its 1/2, 2/2, Im just looking for something like that i guess.
I see, well my above suggestion was as close to what you're looking for as currently possible. You could also check p. 995 of the manual, if you like.
Perhaps, if you could expand a bit on what your objective / rationale is in seeking this, there might be a workaround. Cheers!
Lower Ruler Beat Count Small Divets
